海尔面板配置指南

介绍

This document provides steps on how to enable the Haier reference panel on SL16XX platforms.

备注

The Haier reference panel was the default output for SL1620 up until v1.3. Follow these instructions to switch back to MIPI output with the Haier panel.

连接

1. Connect the USB cable on the Haier panel’s adapter board to the USB ports on the SL16XX I/O board.

SL16XX I/O board with USB ports highlighted

2. Connect the 22 pin DSI cable to the MIPI DSI connector on the SL16XX I/O board.

SL16XX I/O board with MIPI DSI port highlighted

Picture of the Haier MIPI Panel adapter board connected to the MIPI DSI port on the SL16XX I/O board.

软件配置

The Haier panel can be enabled by setting the dtbo variable, in U-Boot, to the correct device tree overlay.

	SL1620	SL1640	SL1680
DTS Overlay	myna2-haier-panel-overlay.dtbo	platypus-haier-panel-overlay.dtbo	dolphin-haier-panel-overlay.dtbo

Setting the device tree overlay requires booting into U-Boot and setting the dtbo variable to the required device tree overlay. See 带SUBoot的U-Boot提示符 for instructions on getting to the U-Boot prompt.

Once at the U-Boot prompt run the following commands to enable the Device Tree Overlay.

Set the dtbo variables:

=> setenv dtbo myna2-haier-panel-overlay.dtbo

Save the environment to the eMMC so that the new variable will persist across reboots.

=> saveenv
Saving Environment to MMC... Writing to redundant MMC(0)... OK

Optionally, confirm that the variable was correctly set.

=> printenv
altbootcmd=if test ${boot_slot}  = 1; then bootslot set b; bootcount reset;bootcount reset; run bootcmd; else bootslot set a; bootcount reset; bootcount reset; run bootcmd;  fi
autoload=n
baudrate=115200
bootcmd=bootmmc
bootcount=1
bootdelay=0
bootlimit=3
dtbo=myna2-haier-panel-overlay.dtbo
fdtcontroladdr=2172e190
preboot=show_logo;
upgrade_available=0
ver=U-Boot 2019.10 (Nov 21 2024 - 14:01:42 +0000)
Environment size: 407/65531 bytesboo

Finally, boot with the new overlay applied.

=> boot